Chevron Digital Timer Ew-32 User Manual Hot!

Using stopwatch (count-up)

Randomly staggers on/off times to make an empty home look occupied. Technical Specifications Voltage: 120V AC, 60Hz Maximum Load: 15A Resistive, 15A General Purpose Wattage Capacity: 1800W Inductive/Ballast Rating: 8A / 1000W Minimum Switching Time: 1 Minute Accuracy: ± 1 minute per month 2. Initial Setup and Resetting the Timer

Check that the timer is set to mode, not manual ON or OFF.

No action required; the click indicates the internal relay is opening or closing the electrical circuit. chevron digital timer ew-32 user manual

Hold down to view the current time; used in combination with other keys to set the clock.

The EW-32 allows up to 7 distinct ON/OFF programs. Programs can apply to a single day, weekdays, weekends, or the entire week. Setting a Program Event

Plug the unit into a live wall socket for 30 minutes, then press the Master Clear button. Mode is set incorrectly or device is off. Using stopwatch (count-up) Randomly staggers on/off times to

Repeat steps 1 through 6 for additional programs ( 2 ON , 2 OFF , etc.).

Press the DAY and HOUR buttons simultaneously while in AUTO mode. A "TIMER" or "RND" icon will flash on the display.

Press until the target start hour (checking AM/PM) is shown. Press MIN to select the target start minute. Step 4: Configure the OFF Time No action required; the click indicates the internal

Before plugging in your device, ensure your electrical load matches the timer ratings to prevent overheating or damage. Chevron EW-32 Input Voltage: 125VAC, 60Hz

If you want to disable an active program without wiping out the whole timer, navigate to that program (e.g., "1 ON") using the button. Press the RST/RCL button. The time values will be replaced with dashes --:-- . Pressing RST/RCL again restores the original time value. 5. Understanding the ON/AUTO/OFF Operating Modes

Before programming, you must set the correct time. If the screen is blank or flashing, install/replace the backup battery (CR2032).

Press and hold the and HOUR buttons simultaneously (or CLOCK and MIN on some variants).