: A pocket-sized, blue ABS plastic meter with an IP54 rating (dust and splash-proof). Power Source : Two 1.5V AAA batteries .
If the device displays an error code (e.g., Err1, Err2), the manual suggests the following:
To switch between meters, feet, inches, or fractional feet/inches:
Beyond simple point-to-point distances, the Dtape DT50 features built-in mathematical formulas to automate complex layout tasks. Area Calculation ( m2m squared ft2f t squared
Disclaimer: This article is for informational purposes and does not replace the official dTape DT50 user manual PDF. Always refer to the original manufacturer’s document for safety-critical instructions.
Press the button three times until a right-angle triangle icon appears.
Clears the last entry or error on the screen. Press and hold to turn off the device. Step-by-Step Operating Instructions Basic Distance Measurement Press the MEAS button to turn on the device. Aim the red laser dot at your target destination.
The result appears immediately on the bottom line of the screen. Changing the Reference Point
Use the and - buttons to adjust the internal offset baseline by up to ±7mm.
: Check the battery level; low power can cause a faint laser beam.
: You can find downloadable or viewable PDF versions on Scribd , which include full diagrams and multi-page technical specs.
External site that opens in a new window
External site that opens in a new window
External site that opens in a new window
External site that opens in a new window
