Two Trees Sapphire Pro Firmware Upd ^hot^ -

Once finished, the printer will boot into the new interface. You may need to calibrate the touchscreen on the first start. 4. Final Steps (Resetting EEPROM)

Locate the binary file. For MKS boards, you must rename this file to exactly (or the name specified by your specific board version) for the bootloader to recognize it. Step 4: Flash the Motherboard

The MKS Robin Nano is picky. Use a low-capacity card and ensure it is formatted correctly to FAT32. If you'd like to dive deeper into the setup: two trees sapphire pro firmware upd

Better utilization of the MKS Robin Nano’s TMC2208/2225 drivers.

Before updating, you must identify which mainboard version your Sapphire Pro uses. Two Trees has shipped the Sapphire Pro with different boards over its production run. Once finished, the printer will boot into the new interface

Ensure thermal runaway protection is active to prevent fire hazards.

Turn off the printer, re-flash with a properly formatted card. Ensure the .bin file is in the root directory. Firmware Not Updating: Try a different SD card. The Sapphire Pro Final Steps (Resetting EEPROM) Locate the binary file

Click the checkmark icon in the PlatformIO bottom toolbar to compile the project. Once successful, navigate to the output build folder.

Use to customize parameters like HOMING_FEEDRATE , BED_LEVELING , and PID_PARAMS . Compile the firmware and flash using the method above. Conclusion Performing a Two Trees Sapphire Pro

Power on the printer, and the screen will automatically update the interface. 4. Customizing Your Firmware (Marlin)